1995 CHEVROLET Monte Carlo Recalls

Recalls Found

All Recalls

CERTAIN DELPHI FUEL PRESSURE REGULATORS, P/NOS. FP10020-11B1, FP10026-11B1, AND FP10027-11B1, SOLD AFTER JANUARY 9, 2007, AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES LISTED ABOVE. THE UNIVERSAL PRESSURE REGULATORS (UPR) WERE PRODUCED WITHOUT AN O'RING AND RETAINER.

NHTSA 07E021000

Report Date

12/03/2007

Component

FUEL SYSTEM, OTHER:STORAGE:TANK ASSEMBLY:PRESSURE RELIEF DEVICES

Manufacturer

DELPHI

Consequence: FUEL MAY LEAK, POSSIBLY RESULTING IN A FIRE.

Remedy / Corrective Action

DELPHI WILL NOTIFY OWNERS AND REPLACE THE UPR FREE OF CHARGE. THE RECALL BEGAN ON APRIL 23, 2007. OWNERS CAN CONTACT DELPHI AT 877-411-8770.

THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: 1995-1999 CHEVROLET MONTE CARLO Z34 PASSENGER VEHICLES. THE BRAKING PERFORMANCE IN WET WEATHER OR WET ROAD CONDITIONS IS REDUCED MORE THAN A DRIVER WOULD EXPECT.

NHTSA 01I014000

Report Date

24/09/2001

Component

SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS

Manufacturer

GENERAL MOTORS CORP.

Consequence: THE BRAKING COULD FEEL DELAYED MOMENTARILY WHEN LIGHT OR MODERATE FORCE IS APPLIED ON THE BRAKE PEDAL WHILE DRIVING ON WET ROADS OR AFTER GOING THROUGH A CAR WASH.

Remedy / Corrective Action

DEALER WILL MODIFY THE FRONT FENDER LINERS TO REMOVE A PORTION OF THE CLOSEOUT PANELS IN THE FRONT WHEEL WELLS AT NO CHARGE TO THE CONSUMER. THIS SERVICE WILL BE AVAILABLE THROUGH AUGUST 2004.

SOME OF THESE VEHICLES HAVE A STRAINED OR SEPARATED WASHER/WIPER SWITCH POWER FEED WIRE.

NHTSA 97V017000

Report Date

11/02/1997

Component

VISIBILITY:WINDSHIELD WIPER/WASHER:SWITCH/WIRING

Manufacturer

GENERAL MOTORS CORP.

Consequence: THIS CAN CAUSE THE WINDSHIELD WASHER/WIPER TO WORK INTERMITTENTLY AND COULD ULTIMATELY RESULT IN INOPERATIVE WIPERS. IF THIS WERE TO OCCUR IN A SEVERE WEATHER SITUATION, DRIVER VISIBILITY COULD BE REDUCED, INCREASING THE RISK OF A VEHICLE CRASH.

Remedy / Corrective Action

DEALERS WILL INSPECT AND REPLACE THE OLD DESIGNED WASHER/WIPER SWITCHES WITH A NEWLY DESIGNED SWITCH.

A RIGHT-HAND LOWER CONTROL ARM TAPERED BALL JOINT MOUNTING HOLE WAS INCORRECTLY MACHINED. MOVEMENT WITHIN THIS ATTACHMENT CAN ALLOW THE BALL JOINT STUD TO FATIGUE AND FRACTURE.

NHTSA 94V230000

Report Date

21/11/1994

Component

SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT

Manufacturer

GENERAL MOTORS CORP.

Consequence: IF THE BALL JOINT FRACTURED WHILE THE VEHICLE WAS IN MOTION, LOSS OF STEERING CONTROL TO THE VEHICLE CAN OCCUR.

Remedy / Corrective Action

DEALERS WILL REPLACE THE RIGHT-HAND LOWER CONTROL ARM AND BALL JOINT STUD ON ALL INVOLVED VEHICLES.

THE CENTER REAR SEAT BELT ANCHOR PLATE EXHIBITS STRESS CRACKS.

NHTSA 97V065000

Report Date

18/04/1997

Component

SEAT BELTS:FRONT:ANCHORAGE

Manufacturer

GENERAL MOTORS CORP.

Consequence: IN THE EVENT OF A VEHICLE CRASH, THE SEAT BELT SYSTEM CAN FRACTURE AND INJURY TO THE SEAT OCCUPANT CAN OCCUR.

Remedy / Corrective Action

DEALERS WILL REPLACE THE CENTER REAR SEAT BELT SYSTEM.

⭐

4.8/5.0

100 reviews

Frequently Asked Questions

How many recalls does the 1995 CHEVROLET Monte Carlo have?

The 1995 CHEVROLET Monte Carlo currently has 5 recalls according to NHTSA records. All recall information is sourced directly from the National Highway Traffic Safety Administration database.

Are 1995 CHEVROLET Monte Carlo recalls free to fix?

Yes! All safety recalls for 1995 CHEVROLET Monte Carlo vehicles must be repaired free of charge by authorized dealers, regardless of vehicle age or mileage. Contact your local CHEVROLET dealer to schedule a recall repair.

How do I check if my 1995 CHEVROLET Monte Carlo has open recalls?

You can check for open recalls by entering your VIN (Vehicle Identification Number) in our VIN decoder tool. The 17-character VIN can be found on your vehicle registration, insurance card, or on the driver's side dashboard visible through the windshield.