2011 INTERNATIONAL Workstar Recalls

VIN Decoder

Premium Report

Recalls Found

Radar Detector GPS Tracker OBD2 Scanner Car Refrigerator Jump Starter Dash Cam

As an Amazon Associate, ForCar.org earns from qualifying purchases.

All Recalls

Navistar, Inc. (Navistar) is recalling certain model year 2010-2014 International Durastar trucks manufactured May 13, 2009, to June 24, 2013, 2011-2012 International Workstar trucks manufactured November 30, 2010, to September 26, 2011, and 2010-2014 IC Bus HC transit buses manufactured November 19, 2009, to April 24, 2013. The affected vehicles may have an improperly routed engine grid heater power feed cable which can result in the cable contacting the metal edge on the cab.

NHTSA 15V394000

Report Date

22/06/2015

Component

ELECTRICAL SYSTEM:WIRING

Manufacturer

Navistar, Inc.

Consequence: If the cable contacts the metal edge of the cab, it may cause an electrical short, increasing the risk of a fire.

Remedy / Corrective Action

Navistar will notify owners, and dealers will secure the power feed cable so that it cannot contact the cab, free of charge. The recall began on August 3, 2015. Owners may contact Navistar customer service at 1-800-448-7825. Navistar's number for this recall is 15514.

Navistar, Inc. (Navistar) is recalling certain model year 2011-2015 International DuraStar, ProStar, TranStar and WorkStar, 2012-2015 International TerraStar, 2013-2015 International LoneStar and IC Bus HC, and 2014-2015 IC Bus AC vehicles. A vehicle double battery jump start or electrical load dump event could result in an overvoltage condition of a component within the HVAC system linear power module (LPM) which is used to control the blower speed. The overvoltage condition could result in the overheating and failure of the LPM.

NHTSA 15V241000

Report Date

22/04/2015

Component

VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM:FAN/MOTOR

Manufacturer

Navistar, Inc.

Consequence: If the LPM overheats and fails, there is an increased risk of a fire.

Remedy / Corrective Action

Navistar will notify owners, and dealers will replace the LPM with an upgraded one, free of charge. An interim letter was mailed to owners on June 18, 2015. A second notification will mailed when parts become available. The recall began on August 6, 2015. Owners may contact Navistar customer service at 1-800-448-7825. Navistar's number for this recall is 15509.

NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2012-2013 IC BUS CE-C, HC, AND INTERNATIONAL 9400 AND CERTAIN MODEL YEAR 2011 THROUGH 2013 INTERNATIONAL DURASTAR, PAYSTAR, WORKSTAR, TRANSTAR, LONESTAR, PROSTAR, 9200, AND 9800, AND CERTAIN MODEL YEAR 2013 INTERNATIONAL 9900, VEHICLES, MANUFACTURED FROM DECEMBER 2, 2010, THROUGH JANUARY 26, 2012, AND EQUIPPED WITH BENDIX ATR-6 TRACTION RELAY VALVES. IN EXTREMELY COLD CONDITIONS, THESE BENDIX RELAY VALVES MAY POTENTIALLY DEVELOP INTERNAL LEAKAGE. INTERNAL LEAKAGE CAN LEAD TO AIR PRESSURE BEING DELIVERED TO AFFECTED PRIMARY OR SECONDARY BRAKES CAUSING CONTINUOUS BRAKE APPLICATION.

NHTSA 12V052000

Report Date

13/02/2012

Component

SERVICE BRAKES, AIR:SUPPLY:CHECK VALVE

Manufacturer

NAVISTAR, INC

Consequence: UNEXPECTED CONTINUOUS BRAKE APPLICATION CAN CAUSE THE BRAKES TO OVERHEAT AND LEAD TO A FIRE. UNEXPECTED CONTINUOUS BRAKE APPLICATION CAN CAUSE THE DRIVER TO LOSE CONTROL OF THE VEHICLE, INCREASING THE RISK OF A CRASH. ALSO, THE BRAKES MAY BE APPLIED WITHOUT ILLUMINATING THE BRAKE LIGHTS, FAILING TO GIVE PROPER WARNING TO OTHER DRIVERS.

Remedy / Corrective Action

NAVISTAR WILL NOTIFY OWNERS, AND DEALERS WILL PROVIDE A TEMPORARY REPAIR UNTIL BENDIX DEVELOPS A PERMANENT REMEDY. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON APRIL 10, 2012. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.

NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2010-2012 PAYSTAR, WORKSTAR, TRANSTAR, AND PROSTAR COMMERCIAL TRUCKS MANUFACTURED FROM JUNE 1, 2009, THROUGH MAY 31, 2011, EQUIPPED WITH A MAXXFORCE 11 OR 13 ENGINE (FEATURE CODE 12UXJ OR 12UXH) AND WITH ALTERNATOR FEATURE CODE 08GGN, 08GGR, 08 GHG, OR 08GHH. THE ALTERNATOR CABLE MAY RUB ON THE HIGH PRESSURE POWER STEERING HOSE, POSSIBLY CHAFING ITS INSULATION AND CAUSING AN ELECTRICAL SHORT.

NHTSA 11V426000

Report Date

17/08/2011

Component

ELECTRICAL SYSTEM:ALTERNATOR/GENERATOR/REGULATOR

Manufacturer

NAVISTAR, INC

Consequence: AN ELECTRICAL SHORT MAY CAUSE A VEHICLE FIRE POSSIBLY RESULTING IN PROPERTY DAMAGE, PERSONAL INJURY, OR DEATH.

Remedy / Corrective Action

NAVISTAR WILL INSTALL A BRACKET TO ROUTE THE WIRES AWAY FROM THE POWER STEERING HOSE. NAVISTAR DID NOT PROVIDE AN EXPECTED START DATE FOR THE RECALL, BUT AN INTERIM NOTICE WILL BE MAILED TO OWNERS IF PARTS WILL NOT BE AVAILABLE UNTIL AFTER OCTOBER 14, 2011. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825. THIS RECALL CAMPAIGN HAS BEEN SUPERSEDED BY 12V-196.

Navistar is recalling certain model year 2011-2012 International Lonestar, model year 2012-2013 International Terrastar and model year 2011-2013 International DuraStar, ProStar, TranStar, and WorkStar commercial trucks manufactured from June 1, 2010, through March 7, 2012 and equipped with day cab codes 16CAB, 16030, or 16196 and feature codes 16WCE, 16WCR, 16XWD, 16XWE, 16XWV, 16XXB, 16XXD, 16XXE, 16XXG, or 16XYN sun shades. The sun shade may not be properly secured to the cab roof panel which may result in partial or full separation of the sun shade from the roof panel.

NHTSA 13V146000

Report Date

17/04/2013

Component

VISIBILITY

Manufacturer

Navistar, Inc.

Consequence: If the sun shade separates from the cab roof during vehicle operation, the sudden release of the sun shade could distract the driver increasing the risk of a crash.

Remedy / Corrective Action

Navistar will notify owners, and dealers will inspect and strengthen the sun shade mounting, free of charge. The safety recall began on September 10, 2013. Owners may contact Navistar at 1-800-448-7825. Navistar's campaign number is 13505.

NAVISTAR IS RECALL CERTAIN MODEL YEAR 2011 AND 2012 INTERNATIONAL DURASTAR AND WORKSTAR COMMERCIAL TRUCKS MANUFACTURED FROM OCTOBER 19, 2010, AND FEBRUARY 3, 2011, EQUIPPED WITH GUNITE AUTOMATIC SLACK ADJUSTERS. DUE TO AN INCOMPLETE "KNITTING" OF THE IRON AT THE TIME OF CASTING, INADEQUATE STRUCTURAL INTEGRITY OF THE SLACK ADJUSTER HOUSING CAN OCCUR, WHICH COULD CAUSE THE HOUSING TO BREAK AT THE HANDLE UNDER NORMAL OPERATING LOADS.

NHTSA 11V167000

Report Date

14/03/2011

Component

SERVICE BRAKES, AIR:SLACK ADJUSTERS:AUTOMATIC

Manufacturer

NAVISTAR, INC

Consequence: IF THE SLACK ADJUSTER HOUSING WERE TO BREAK, THE WHEEL BRAKE TO WHICH THE SLACK ADJUSTER IS ATTACHED WOULD NO LONGER FUNCTION, REDUCING BRAKING CAPACITY AND, IN SOME CASES, CAUSING THE VEHICLE TO PULL TO ONE SIDE. REDUCED BRAKING PERFORMANCE AND/OR LOSS OF STEERING CONTROL INCREASES THE RISK OF A CRASH.

Remedy / Corrective Action

NAVISTAR WILL NOTIFY OWNERS AND DEALERS WILL REPLACE THE SUBJECT SLACK ADJUSTERS FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN ON OR ABOUT APRIL 1, 2011. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.

NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2010 THROUGH 2013 PAYSTAR, WORKSTAR, TRANSTAR, AND PROSTAR, AND MODEL YEAR 2012 AND 2013 LONESTAR COMMERCIAL TRUCKS MANUFACTURED FROM JUNE 1, 2009, THROUGH APRIL 4, 2012, EQUIPPED WITH A MAXXFORCE 11 OR 13 ENGINE (FEATURE CODE 12UXJ OR 12UXH) AND WITH BOSCH ALTERNATOR FEATURE CODES 08GGN, 08GGR, 08GHG, OR 08GHH. THE ALTERNATOR CABLE MAY RUB ON THE HIGH PRESSURE POWER STEERING HOSE, POSSIBLY CHAFING ITS INSULATION AND CAUSING AN ELECTRICAL SHORT.

NHTSA 12V196000

Report Date

02/05/2012

Component

ELECTRICAL SYSTEM:ALTERNATOR/GENERATOR/REGULATOR

Manufacturer

NAVISTAR, INC

Consequence: AN ELECTRICAL SHORT MAY CAUSE A VEHICLE FIRE POSSIBLY RESULTING IN PROPERTY DAMAGE, PERSONAL INJURY, OR DEATH.

Remedy / Corrective Action

NAVISTAR WILL INSTALL A STANDOFF BRACKET AND IMPROVE HARNESS ROUTING TO BETTER ROUTE THE ALTERNATOR WIRES AWAY FROM THE POWER STEERING HOSE. THE SAFETY RECALL BEGAN ON JULY 16, 2012. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.

NAVISTAR IS RECALL CERTAIN MODEL YEAR 2011 AND 2012 INTERNATIONAL DURASTAR, PAYSTAR, WORKSTAR, TRANSTAR, LONESTAR AND PROSTAR COMMERCIAL TRUCKS MANUFACTURED FROM NOVEMBER 5, 2010, THROUGH MARCH 10, 2011, FOR FAILING TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, "AIR BRAKE SYSTEMS (ABS)." THE TRAILER ABS FAULT INDICATOR LAMP IN THE INSTRUMENT CLUSTER WILL NOT ILLUMINATE DUE TO A PROGRAMMING OR HARDWARE ISSUE WITH THE BRAKE SYSTEM ELECTRONIC CONTROL UNIT.

NHTSA 11V252000

Report Date

19/04/2011

Component

SERVICE BRAKES, AIR:ANTILOCK:CONTROL UNIT/MODULE

Manufacturer

NAVISTAR, INC

Consequence: AN INOPERABLE TRAILER ABS FAULT INDICATOR MAY PREVENT THE DRIVER FROM BEING AWARE OF A TRAILER ABS FAULT CONDITION THEREBY POSSIBLY INCREASING THE RISK OF A CRASH POTENTIALLY RESULTING IN PROPERTY DAMAGE, PERSONAL INJURY, OR DEATH.

Remedy / Corrective Action

NAVISTAR WILL NOTIFY OWNERS. DEALERS WILL REPROGRAM OR REPLACE THE BRAKE SYSTEM ELECTRONIC CONTROL UNIT FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MAY 12, 2011. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.

4.9/5.0

29 reviews

Where to Find VIN for Recall Check

To check for recalls on your 2011 INTERNATIONAL Workstar, you'll need the VIN number. Find your VIN in one of these 4 common locations.

Where to Find VIN Number on 2011 INTERNATIONAL Workstar for Recall Lookup - Dashboard, Door Jamb, Engine Bay, Documents

Understanding VIN Structure for Recall Verification

Each character in your 2011 INTERNATIONAL Workstar 17-digit VIN helps identify specific recalls affecting your vehicle. Learn how the VIN structure works for accurate recall lookup.

2011 INTERNATIONAL Workstar VIN Structure for Recall Verification - WMI, VDS, Check Digit, Model Year, Plant Code

How to Check 2011 INTERNATIONAL Workstar Recalls in 3 Steps

Locate Your VIN

Find the 17-character VIN on your 2011 INTERNATIONAL Workstar dashboard (visible through windshield), door jamb, engine bay, or vehicle documents.

Enter VIN in Checker

Input your VIN into our free recall checker tool above to search NHTSA database for safety recalls, TSBs, and service campaigns specific to your vehicle.

Review & Schedule Repair

Check the recall details including affected components, consequences, and remedy. Contact your INTERNATIONAL dealer to schedule free recall repair appointment.

Frequently Asked Questions

How many recalls does the 2011 INTERNATIONAL Workstar have?

The 2011 INTERNATIONAL Workstar currently has 8 recalls according to NHTSA records. All recall information is sourced directly from the National Highway Traffic Safety Administration database.

Are 2011 INTERNATIONAL Workstar recalls free to fix?

Yes! All safety recalls for 2011 INTERNATIONAL Workstar vehicles must be repaired free of charge by authorized dealers, regardless of vehicle age or mileage. Contact your local INTERNATIONAL dealer to schedule a recall repair.

How do I check if my 2011 INTERNATIONAL Workstar has open recalls?

You can check for open recalls by entering your VIN (Vehicle Identification Number) in our VIN decoder tool. The 17-character VIN can be found on your vehicle registration, insurance card, or on the driver's side dashboard visible through the windshield.

Where can I find my 2011 INTERNATIONAL Workstar VIN number?

Your 2011 INTERNATIONAL Workstar VIN is located in 4 places: (1) Dashboard near windshield on driver's side, (2) Driver's door jamb sticker, (3) Engine bay, (4) Vehicle registration and insurance documents.

What should I do if my 2011 INTERNATIONAL Workstar has a recall?

Contact your nearest INTERNATIONAL dealership immediately to schedule a free recall repair. Bring your vehicle registration or VIN number. All safety recalls must be fixed free of charge by the manufacturer, regardless of vehicle age or mileage.

Are NHTSA recalls mandatory to fix on 2011 INTERNATIONAL Workstar?

While not legally required for vehicle owners to fix recalls, it's strongly recommended for safety. However, dealerships and manufacturers must offer free repairs for all official NHTSA recalls on 2011 INTERNATIONAL Workstar vehicles.