1991 CHEVROLET Lumina Recalls

Recalls Found

All Recalls

SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

NHTSA 09E012000

Report Date

07/04/2009

Component

EXTERIOR LIGHTING

Manufacturer

SABERSPORT

Consequence: DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.

Remedy / Corrective Action

SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.

CERTAIN DELPHI FUEL PRESSURE REGULATORS, P/NOS. FP10020-11B1, FP10026-11B1, AND FP10027-11B1, SOLD AFTER JANUARY 9, 2007, AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES LISTED ABOVE. THE UNIVERSAL PRESSURE REGULATORS (UPR) WERE PRODUCED WITHOUT AN O'RING AND RETAINER.

NHTSA 07E021000

Report Date

12/03/2007

Component

FUEL SYSTEM, OTHER:STORAGE:TANK ASSEMBLY:PRESSURE RELIEF DEVICES

Manufacturer

DELPHI

Consequence: FUEL MAY LEAK, POSSIBLY RESULTING IN A FIRE.

Remedy / Corrective Action

DELPHI WILL NOTIFY OWNERS AND REPLACE THE UPR FREE OF CHARGE. THE RECALL BEGAN ON APRIL 23, 2007. OWNERS CAN CONTACT DELPHI AT 877-411-8770.

CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.

NHTSA 06E043000

Report Date

19/05/2006

Component

FUEL SYSTEM, GASOLINE

Manufacturer

HONEYWELL INTERNATIONAL, INC.

Consequence: THIS CONDITION MAY CAUSE AN INADEQUATE SEAL AT THE CONNECTION, POTENTIALLY LEADING TO A FUEL LEAK. IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.

Remedy / Corrective Action

HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).

VEHICLE DESCRIPTION: PASSENGER VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, WEST VIRGINIA, WISCONSIN, AND THE DISTRICT OF COLUMBIA, WHERE ROAD SALT USE IS HEAVY. A CONDITION WHERE ONE OR BOTH FRONT ENGINE CRADLE BOLTS CAN PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINERS.

NHTSA 00V189000

Report Date

11/07/2000

Component

STRUCTURE

Manufacturer

GENERAL MOTORS CORP.

Consequence: IF BOTH BOLTS PULL THROUGH, THE FRONT OF THE CRADLE WOULD NO LONGER BE SUPPORTED AT THE MOUNTING LOCATIONS AND THE STEERING INTERMEDIATE SHAFT COULD SEPARATE FROM THE STEERING GEAR.

Remedy / Corrective Action

DEALERS WILL REPLACE THE FRONT AND REAR FRAME/CRADLE BOLTS AND RETAINERS.

THE FRONT DOOR SHOULDER BELT GUIDE LOOPS MAY BE CRACKED AND ARE NOT IN COMPLIANCE WITH FMVSS 208.

NHTSA 92V003000

Report Date

10/01/1992

Component

SEAT BELTS

Manufacturer

GENERAL MOTORS CORP.

Consequence: THE SEAT OCCUPANT FACES INCREASED RISK OF INJURY IN THEEVENT OF A SUDDEN STOP OR ACCIDENT.

Remedy / Corrective Action

INSTALL REINFORCING PLATES ON THE CRACKED SHOULDER BELT GUIDES.

VEHICLE DESCRIPTION: PASSENGER VEHICLES AND MINI VANS ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT AND WISCONSIN. THE REAR CRADLE BOLTS PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINER. IF BOTH BOLTS PULL THROUGH, THE REAR CRADLE WOULD NOT LONGER BE SUPPORTED AT THESE MOUNTING LOCATIONS AND THE STEERING INTERMEDIATE SHAFT CAN SEPARATE FROM THE STEERING GEAR.

NHTSA 97V058000

Report Date

08/04/1997

Component

STRUCTURE

Manufacturer

GENERAL MOTORS CORP.

Consequence: IF THIS WERE TO OCCUR WHILE THE VEHICLE WAS IN MOTION, A VEHICLE CRASH COULD RESULT.

Remedy / Corrective Action

DEALERS WILL REPLACE THE REAR CRADLE BOLTS AND RETAINERS.

⭐

4.4/5.0

34 reviews

Frequently Asked Questions

How many recalls does the 1991 CHEVROLET Lumina have?

The 1991 CHEVROLET Lumina currently has 6 recalls according to NHTSA records. All recall information is sourced directly from the National Highway Traffic Safety Administration database.

Are 1991 CHEVROLET Lumina recalls free to fix?

Yes! All safety recalls for 1991 CHEVROLET Lumina vehicles must be repaired free of charge by authorized dealers, regardless of vehicle age or mileage. Contact your local CHEVROLET dealer to schedule a recall repair.

How do I check if my 1991 CHEVROLET Lumina has open recalls?

You can check for open recalls by entering your VIN (Vehicle Identification Number) in our VIN decoder tool. The 17-character VIN can be found on your vehicle registration, insurance card, or on the driver's side dashboard visible through the windshield.